To check if the adjustment has been made to your liking, turn the system back on and see. To adjust a spray head, you will need a screwdriver to adjust the length of the stream and a wrench to change its direction.
Adjust until the left travel limit is where you want it. To change the flow and radius, use a screw on the stainless-steel screw on the nozzle. Turning the key toward the plus sign moves the left travel limit away from the right limit, increasing the coverage arc. Surface area of the filter has been improved and strengthened. Strong, fortified cap with superior threads. Pre-installed pressure regulator in each head ensures optimal nozzle performance.
Turning the key toward the minus sign moves the left travel limit closer to the right limit, closing the coverage arc. Nozzle easily adjusts spray from part to full circle. Turn the body clockwise to approximately the middle of its travel, insert the plastic end of the rotor key into the hole in the cap that has two arrows pointing to a plus sign and a minus sign. Turn the rotor body counter-clockwise by hand until it reaches its left limit and compare the direction of spray arrow with your desired left edge.
Point the direction of spray arrow at your desired right hand edge, lower the body back into the housing and lock the collar. Lift the rotor body up until the gear on the bottom clears the two ridges in the housing-about one inch before it is completely free of the housing. Turn the collar that locks the rotor body into the housing counter-clockwise until it is free.
